LED Display Blue 6-digits RF Signal Frequency Counter DC 8V~15V 0.1MHz~65MHz

Description

Home
Electronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
LED Display Blue 6-digits RF Signal Frequency Counter DC 8V~15V 0.1MHz~65MHz
Popular
Popular
Product Introduction
Description：
PLJ-6LED-A is a cost-effective six-digit LED frequency display module specially designed for forum HAM friends. It is mainly used to display the frequency value of transceivers and other equipment, and can also be used for regular frequency measurement. This module has the characteristics of small and exquisite, reliable performance, good visual effect and low cost.
Technical Parameters:
1. Gate time
0.1 second
2. Measurement channel
Input impedance: high impedance
Measuring range: 0.1 MHz~65 MHz
Measurement accuracy: 10 Hz
Sensitivity: better than 60mVpp
3. IF setting
Independent dual intermediate frequency design, the minimum step of intermediate frequency adjustment is 100Hz, the intermediate frequency range is 0~99.9999MHz, and the mode of adding intermediate frequency or subtracting intermediate frequency can be set.
4. Frequency reference
Using 5032 package 13.000MHz Temperature Compensated Voltage Controlled Crystal Oscillator (VC-TCXO), the frequency stability is ±2.5ppm.
5. Working voltage
DC input: DC8V~15V (with power reverse polarity protection) or DC5V (hardware setting required).
6. Working current：
Max 90mA
7. Display digits：
Six-digit common anode LED display, the highest display six digits.
8. Display brightness
Eight-level LED brightness is adjustable, and the factory setting is the highest brightness.
9. Physical dimensions：
Length × width × height: 91mm×28mm×20mm
10. Onboard interface
RF IN (signal input): HX2.54-2P socket
ICSP (programming interface): 2.54-6P pin
DC IN (power interface): HX2.54-2P socket
11.Qorking principle
MCU CONTROL
Display and Button control
Package Included:
1PCS* frequency counter
2PCS* connecting wires
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.
Home
Electronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
LED Display Blue 6-digits RF Signal Frequency Counter DC 8V~15V 0.1MHz~65MHz
Product Introduction
Description：
PLJ-6LED-A is a cost-effective six-digit LED frequency display module specially designed for forum HAM friends. It is mainly used to display the frequency value of transceivers and other equipment, and can also be used for regular frequency measurement. This module has the characteristics of small and exquisite, reliable performance, good visual effect and low cost.
Technical Parameters:
1. Gate time
0.1 second
2. Measurement channel
Input impedance: high impedance
Measuring range: 0.1 MHz~65 MHz
Measurement accuracy: 10 Hz
Sensitivity: better than 60mVpp
3. IF setting
Independent dual intermediate frequency design, the minimum step of intermediate frequency adjustment is 100Hz, the intermediate frequency range is 0~99.9999MHz, and the mode of adding intermediate frequency or subtracting intermediate frequency can be set.
4. Frequency reference
Using 5032 package 13.000MHz Temperature Compensated Voltage Controlled Crystal Oscillator (VC-TCXO), the frequency stability is ±2.5ppm.
5. Working voltage
DC input: DC8V~15V (with power reverse polarity protection) or DC5V (hardware setting required).
6. Working current：
Max 90mA
7. Display digits：
Six-digit common anode LED display, the highest display six digits.
8. Display brightness
Eight-level LED brightness is adjustable, and the factory setting is the highest brightness.
9. Physical dimensions：
Length × width × height: 91mm×28mm×20mm
10. Onboard interface
RF IN (signal input): HX2.54-2P socket
ICSP (programming interface): 2.54-6P pin
DC IN (power interface): HX2.54-2P socket
11.Qorking principle
MCU CONTROL
Display and Button control
Package Included:
1PCS* frequency counter
2PCS* connecting wires
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.